Stanley PB2500 - Deleting the Data

- 28 -
20. Deleting the data
About 500,000 riveting data can be stored in the tool. If the number of data reaches 500,000, a
message which recommends deleting the data is shown and alarm goes off.
If the number of data reaches 500,000, a
message which recommends deleting the
data is shown and alarm goes off.
“Almost full capacity, delete the data”
Touch the screen somewhere.
The window switches to “Clear data
conformation” window.
If “Yes” character string is touched, the
deleting process starts, and it takes 1 to 2
minutes. Wait until completing the deleting.
Do not turn off the power of the tool during
this time.
If “No” character is touched, it is back home
for next riveting, but this message appears
every 100 riveting.
If the backup is needed, touch “No” and be
back to “19. Extracting the data” and copy the
data required.
If the backup is not needed, touch “Yes”.
You can also delete the data before this
message appearing.
Touch “12. Clear data” from the setting
menu.
The window switches to Password checking
window.
Input the password.
Touch the figure you want to change and
change the numbers with touching the Up-
Down icons.
*Default password : 2000
After inputting, Touch the “Back” icons.