Stanley PB2500 - Troubleshooting; Troubleshooting Guide

- 32 -
Troubleshooting Guide
*Read Instruction manual for tool itself together to understand the troubleshooting of tool.
Symptom Cause Remedy Page
Power does not turn
on.
1. Battery is not fully seated
Remove battery and re-insert.
Reset tool to home.
Refer to tool
manual
2. Battery is not fully charged
Charge battery
Refer to tool
manual
3. Battery is defective
Replace battery
-
4. Battery pack has reached operating
temperature limit through continuous
use or defect
Remove battery & allow to cool.
Mount battery and reset tool to
home.
-
Screen freezes in
Stanley Engineered
Fastening Logo.
1. Data reading fails
Remove battery and re-insert.
Press trigger to turn on.
-
2. Smart screen is defective
Contact a local service center
-
3. Trigger module is defective
Replace motor & module
assembly
-
4. Setting data are broken
Restore to factory settings
P31
Tool does not
operate when
trigger switch
is pressed.
1. Screen is not home screen(Counter
screen)
Change screen to home screen.
Touch “Back home” icon to be
back home.
P9
2. Screen freezes
Even if touch screen, screen doesn not
respond or screen becomes all white.
Remove battery and re-insert.
Press trigger to turn on.
If does not revert, contact local
service center.
-
3. Alarm message is shown with beep
sound.
Reset alarm refering to the
related pages.
each
4. Setting data are broken
Restore to factory settings
P31
5. Radio communication error
Even if restores to factory
settings, if does not revert,
contact local servicre center.
-
Tool shows NOK,
even if it sets rivet
correctly.
1. Judgement range setting is not
correct
Set judgement range correctly
P15, 16
2. Judgement range setting is too small
Set appropriate range
P15, 16
3. Not fasten 5 rivets in average mode
Fasten 5 rivets, if it has an error,
do it again
P.15
4. Jaw slips.
Do maintenane around jaw area
Refer to tool
manual
5. Tool is not at home position
Reset tool to home
Refer to tool
manual
6. There is a problem in tool.
Remove cause of issue or contact
local service center
-
7. Trigger module is defective.
Replace motor & module
assembly or contact local service
center
-