Set vertical tab stops
node ] ASCII
I
Decimal
I Hexadecimal
I
<ESC> “B”
Both
Ill
fl~
27 66 nl 112
IB 42 nl n2
<t)>
0 00
Cancels all current vertical tab stops and sets new vertical tab stops
at lines
nl, n2, etc., where nl, n2, etc. are numbers between 1 and
255. A maximum of 16vertical tab stops can be set. The tab stops
must be specified in ascending order; any violation of ascending
order terminates the tab stop list.Standard termination isby the <0>
controlcode. The verticaltab stopsaresetinterms ofthecurrent line
spacing and do not move if the line spacing is changed later.
Set vertical tab stops every n lines
Mode Ascll Decimal
Hexadecimal
Std.
<ESC> “e” <I> n
27
101 1 n
IB 65 01 n
Cancels all current vertical tab stops and sets new tab stopsevery n
lines. where
n is between 2 and 127.
Set vertical tab stops in channel
Mode
ASCII Decimal
Hexadecimal
Std.
<ESC> “b” II()
nl 27 98 no n/ IB 62 no n]
d ,... <()> d 0
n2 00
Cancels all current vertical tab stops in channel M, (where nOis
between Oand 7) and sets new vertical tab stops in this channel. (A
channel is a set of vertical tab stops selected by the <ESC> “/”
command.) See <ESC> “B” for parameters
nZ, n2, ... <0>.
Select vertical tab channel
Mode ASCII
Decimal Hexadecimal
Std.
<ESC> “/”
no 27 47 no IB 2F no
Selects a set of vertical tab stops designated by a channel number
(nO)fromOto 7.The tab stopsineach channel are setby <ESC> “b”.
102
To Next Page
Loading...
