Star Micronics LC24-20 - Font Control Commands

FONT CONTROL COMMANDS
Select print quality
Mode
ASCII
Decimal Hexadecimal
Std.
<ESC> “X” 17
27 120 n 1B 78 n
“Changesthe print quality according to the value of n, as shown be-
low:
n
Print quality
o
Draft
1
Letter quality
Ignored if the FONT LOCK mode was selected during power-up.
Select print quality
Mode
ASCII
Decimal Hexadecimal
IBM
I<ESC> “[”
“d”
<I> <0> n \
27 91100 1 0 n I IB 5B 64 01 00 n
Changes the print quality according to the value of n, as shown be-
low:
}1
Print quality
o
Unchanged
1-127
Draft
128-254
Letter quality
255
Return to EDS setting
Ignored if the FONT LOCK mode was selected during power-up.
Select LQfont
Mode
ASCII
Decimal Hexadecimal
Both
<ESC> “k” H
27 107 H IB 6B n
Selects an LQ font according to the value of n. In draft mode, this
command remains dormant and takes effect later when LQ is se-
lected. Ignored if the FONTLOCKmode was selected during power-
up or the corresponding Font Cartridge is not installed.