I
INTERFACE CONVERTER (SPC-8K)
To run the printer in serialmode. you should use the optional Serial/Parallel
Converter (SPC-8K).
The procedure to install the Converter is:
1.
7
-.
3.
4.
5.
[
L
SettheDIPswitchesontheSPC-8K beforeattaching ittotheprinter.(See
next page for detailed information.)
Turn off the power switch and disconnectthepower cord from the power
source.
Disconnect the interface cable if attached.
Connect the Parallel connector to the printer.
Moveboth c1ips insidethe extended prongson the sidesof the plug until
you hear a click.
Figure 7-21. Connect the Parallel connector to the printer
6. Connect the Serial connector to your computer.
NOTE: Place the Converter on a table in order not to damage the cable.
...
, ~
K
zy2 ,“
+’”
//
,,/
“r
\..-
/
I ;’
t
Figure 7-22. Place the converter on a table.
78
To Next Page
Loading...
