NOTES:
1.
Never feed labels backward. Labels can easily peel off the backing
and get stuck
in the printer.
To remove labelsfromthepaperpath after youfinish printing,first
tear off the labels at a point before the paper slot.
2. Use labels only under normal operating conditions.
The labels are especially sensitive to temperature and humidity.
3. Do not leave labels loaded in the printer between jobs. They curl
around the platen and may jam when you resume printing.
Figure 3-1 shows the recommended print area for each type of papers.
Perf[
Fanfold forms
Single sheets
9
1
75mm
J
0
Bottom of 0
(8mm for Bottom Feed) ~
Forms
18mm
5mm
17mm
r ‘ ,
Figure 3-7. Recommended print area for acceptable papers
20
To Next Page
Loading...
