Switch B-2: Paper-out
When this switch isOFF the printer ignoresthe paper-out detector and
prints down to (and beyond) the bottom edge.
Switch B-4:This switch is used for technical purpose only. Leave this
switch ON.
Switch B-5: Printable area
This printer can use two typesof printing area format for single sheets
(cut forms).
Byputting theswitchON (“TypeA“), thetopof thefirst lineofprinting
willstart 1/6inchfromthetopofthe paper, and theprinted area willend
1/6inch from the bottom of the paper.
ByputtingtheswitchOFF (“Type B“),the firstlineofprinting willstart
at one inch from the top of the paper, and the printed area will end to
print 6 mm from the bottom of the printer.
Switches C-1 and C-2: Print Mode
These switches select the default print pitch and the fonts as shown
below.
Print Mode
c-1 c-2
10CPIDRAFT
ON ON
IOCPIHS DRAFT ON
OFF
17CPIDRAFT
OFF
ON
10CPILQ OFF
OFF
NOTE: If you change these switches after you have saved a macro,
these new settings will override the macro setting.
52
To Next Page
Loading...
