Enable printing of all character codes
Mode
ASCII
Decimal Hexadecimal
Std.
43> ‘1”
nl n2
28 92 nl n2 IC 5C nl n2
IBM
<ESC> ‘1”
nl n2
27 92 nl n2
10 5C nl n2
Enables printing ofall characters intheIBM character set,including
those assigned to character codes which are normally considered
control codes. This command remains in effect for the next
id + n2
x 256 characters, where nl and n2 are numbers between Oand 255.
During thisintervalno controlfunctionsare executed. If acode with
no assigned character is received, the printer prints a space.
Enable printing of all character codes on next character
Mode ASCII Decimal Hexadecimal
Std.
<FS>
“~.>
n 28 94 n
IC 5E n
IBM <ESC> “A” n 27 94 n IB 5E n
This command operates like <ESC> ‘1” except that it remains in
effect for only one character.
Select slash zero
Mode ASCII Decimal Hexadecimal
Std. <ESC> “-” <1>
27 126 1 IB 7E 01
Causes subsequentzero characters tobe overprintedwith a slash(B).
Select normal zero
Mode
ASCII
Decimal Hexadecimal
Std.
<ESC> “-”
<O> 27 126 0 IB 7E 00
Causes
subsequent zero characters to be printed normally (0),
without a slash.
89
To Next Page
Loading...
