Star Micronics NX-1000 - Macro Instruction Commands

Select draft elite download character set
Mode
ASCII
Decimal Hexadecimal
< ESC > “I” “5”
21 13 53 1B 49 35
IBM
< ESC >
“I”
<.5>
27 13 5
IB 49 05
Selects the download character set, draft quality, and elite pitch (12 cpi).
Ignored if the NLQ Type Style switch was pressed during power-up or
if DIP switch 2-1 is ON.
Select NLO download character set
Mode
ASCII
Decimal Hexadecimal
<ESC> “I” “6”
21 13 54 1B 49 36
IBM
< ESC >
“I”
<6>
21 73 6 1B 49 06
Selects the download character set and near letter quality.
Ignored if the
NLQ Type Style switch was pressed during power-up or if DIP switch
2-l is ON.
Select ROM character set
Mode ASCII
Decimal Hexadecimal
<ESC>
“% 77 “0” 21
31 48 1B 25 30
Both ’
<ESC>
“yo” co> 21
31 0 1B 25 00
Stops using the download character set and returns to the built-in ROM
character set. Ignored when DIP switch 2-l is ON.
MACRO INSTRUCTION COMMANDS
Define macro instruction
Mode
ASCII
Decimal Hexadecimal
Both <ESC>
“ + ” ._._ <RSa 27
43 . . . 30 1B 2B 1E
Cancels any existing macro instruction and replaces it with the defined
instruction. The defined macro instruction consists of the characters
between the “ + ” and -Z RS > . These can be any printable characters
or control characters except < RS >, up to a maximum of 16 characters.
Execute macro instruction
Mode
ASCII
Decimal Hexadecimal
Both
<ESC>
“ + ” < 1 >
21 43 1
1B 2B 01
Executes a previously defined macro instruction.