Star Micronics NX-1000 - Character Set Commands

Stop overlining
Mode
ASCII
Decimal
Hexadecimal
<ESC> “ ”
“0” 21
95 48 IB 5F 30
-
Both
<ESC> “p” <Cl> 27
95 0 IB 5F 00
Stops overlining.
Superscript
Mode ASCII
Decimal
Hexadecimal
<ESC> ‘3” “0” 27
83 48 IB 53 30
Both
<ESC> ‘3” co> 27
83 0 IB 53 00
Causes subsequent characters to be printed as superscripts. Does not
change the character pitch.
Subscript
Mode ASCII
Decimal
Hexadecimal
<ESC> “S” (‘ 1”
27 83 49 1B 53 31
Both
<ESC>
“S” <I>
27 83 1 IB 53 01
Causes subsequent characters to be printed as subscripts. Does not change
the character pitch.
Cancel superscript or subscript
Mode ASCII
Decimal
Hexadecimal
Both
<ESC>
“T”
2-l 84
1B 54
Stops printing superscripts or subscripts and returns to normal printing.
CHARACTER SET COMMANDS
Select standard character set
Mode ASCII
Decimal
Hexadecimal
< ESC > “t”
“0”
27 116 48
IB 74 30
Std.
< ESC > “t”
co>
27 116 0 1B 74 00
Selects the standard character set. This is the power-up default in Standard
mode if DIP switch l-7 is ON. The standard character set cannot be
selected in IBM mode.
63