Line feed
Mode ASCII
Decimal Hexadecimal
Both
<LF>
10
OA
Prints the current line and feeds the paper to the next line. If DIP switch
l-2 is ON, also moves the next print position to the left margin. See the
preceding commands for the line spacing.
Reverse line feed
Mode
ASCII
Decimal Hexadecimal
Both
<ESC>
<LF> 27 10
1B OA
Prints the current line and feeds the paper in the reverse direction to the
preceding line. If DIP switch l-2 is ON, also moves the next print position
to the left margin. See the preceding commands for the line spacing.
Ignored when friction feed is used.
Perform one n/2164nch line feed
Mode ASCII
Decimal
Hexadecimal
Both < ESC > “J” n
27 14 n 1B4A n
Feeds the paper once by n/216 inches, where n is between 1 and 255.
Does not move the print position right or left when DIP switch l-2 is
OFF. Does not change the line-spacing setting. Ignored when friction
feed is used.
Perform one nl2164nch reverse line feed
Mode ASCII
Decimal Hexadecimal
Both
c ESC > “‘j” n
27 106 n 1B6A n
Feeds the paper once by n/216 inches in the reverse direction, where n
is between 1 and 255. Does not move the print position right or left when
DIP switch l-2 is OFF. Does not change the line-spacing setting. Ignored
when friction feed is used.
Feed paper n lines
Mode ASCII
Decimal Hexadecimal
<ESC> “f’
“1” n 27 102
49 n 1B 66 31 n
Both
<ESC> “f
<I> n 27 102
1 n 1B 66 01 n
Feeds the paper n lines from the current line, where n is between 0 and
127.
72
To Next Page
Loading...
