– 8 –
1. Case Unit
(1) Turn off the power switch 1, disconnect the power
cord from the wall outlet.
(2) Lift up the front of printer cover 2 and open printer
cover.
(3) Spread to the outside at points A (left / right) of printer
cover 2 and remove printer cover.
(4) Remove
• Four screws 3
• Case unit 4
Lift the case unit 4.
At this time, avoid the power switch 1.
Caution 1:
When removing the case unit 4, rotate it while pulling
it toward so that it does not hit the FEED switch 5.
It is possible to damage the FEED switch if a strong
force is applied to it.
When remounting the case unit, be careful not to hit the
FEED switch 5.
Caution 2:
After removing or before remounting the case unit,
absolutely never set the mechanical unit 6 with the
FEED switch facing downward.
The FEED switch can be pulled from the frame cause
a strong force to be applied to it which can result in its
becoming damaged.
E
R
R
O
R
P
O
W
E
R
F
E
E
D
1
5
3
2
4
A
A
6
5
To Next Page
Loading...
