Star Micronics SP500 Series - 4-2. Connecting to a Peripheral Unit

– 9 –
<Tear bar type>
2. Printer Mechanism
2-1. Tear bar type
(1) Turn off the power switch, disconnect the power cord
from the wall outlet.
(2) Remove the case unit according to the procedure
described in item 1.
Caution:
Handle the FEED switch 5 carefully as described in the
cautions of item 1.
(3) Remove
• Two screws 1
• Flat cable 3
• Printer mechanism 4
2-2. Auto cutter type
(1) Turn off the power switch, disconnect the power cord
from the wall outlet.
(2) Remove the case unit according to the procedure
described in item 1.
Caution:
Handle the FEED switch 5 carefully as described in the
cautions of item 1.
(3) Remove
• Two screws 1
• Connector 2
• Flat cable 3
• Printer mechanism 4
<Auto cutter type>
1
4
3
5
1
4
3
2
5