– 10 –
3. Auto Cutter Unit
(Auto cutter type only)
(1) Turn off the power switch, disconnect the power cord
from the wall outlet.
(2) Remove the printer mechanism according to the
procedure described in item 2.
(3) Remove
• Two screws 1
• Cutter holder plate R 2
• Cutter holder plate L 3
• Two fasteners 4
• Ferrite core 5
• Auto cutter unit 6
4. Ribbon base
(1) Turn off the power switch, disconnect the power cord
from the wall outlet.
(2) Remove the printer mechanism according to the
procedure described in item 2.
(3) Open the auto cutter unit. (Auto cutter type only)
(4) Remove
• Two screws 1 (Tear bar type only)
• Tear bar 2 (Tear bar type only)
• Screw 3
• Ribbon base 4
Caution in reassembly:
Insert two hooks 5 of the ribbon base into the two
square holes 6 of the frame unit.
3
1
5
6
4
4
1
2
1
6
6
2
3
4
5
5
To Next Page
Loading...
