Star Micronics TSP100LAN User Manual

– 8 –
WARNING
1) Do not touch the cutter blade.
• ereisacutterinsidethepaperoutletslot.Notonlyshouldyounotputyourhandin
the paper outlet slot while printing is in progress, never put your hand into the outlet even
when printing is not in progress.
• eprintercovercanbeopenedwhenreplacingthepaper.However,sincethecutterblade
is on the inside of the printer cover, be careful not to place your face or hands too close to
the cutter blade.
2) During and immediately aer printing, the area around the thermal head is very hot. Do
not touch it, as you could be burned.
Caution Symbol
ese labels are located near the thermal print head.
Because the thermal print head is hot immediately after printing, do not
touch it. Static electricity can damage the thermal print head. To protect the
thermal print head from static electricity, do not touch it.
is symbol is placed near the cutter.
Never touch the cutter blade, as you could injure your ngers.
is symbol is placed near the peripheral drive connector.
Do not connect this to a telephone.
This symbol label or stamp is placed near the screws securing the case or
the protective plate, which should not be opened by individuals other than
service personnel. Individuals, other than service personnel, should not
remove these screws. High voltage areas in the case can be dangerous.
Thermal head

Star Micronics TSP100LAN Specifications

General

Brand	Star Micronics
Model	TSP100LAN
Category	Printer
Language	English