15.3.2 Memory Switch 1 (MSW1)
Bit Function 0 1 STAR ESC/POS Note
F
E
D
C
B
A
Back Feed Setting
Setting 1 Setting 2 ○ × *2
9 Back Feed Function Disabled Enabled ○ × *2
8
TOF Function
Disabled Enabled ○ ○
7
6
5
4 Zero Style Normal Slashed ○ ×
3 International Characters (See Table Below) ○ ×
*3
2 International Characters (See Table Below) ○ × *3
1 International Characters (See Table Below) ○ × *3
0 International Characters (See Table Below) ○ × *3
[*2] When back feed is disabled, the top margin of approximately 13 mm from the printing position to
the cutting position can be set. When printing after cutting the paper, a top margin of over 14 mm is
possible by feeding paper at least 1 mm (8-dot line).
If back feed is enabled, the top margin of approximately 3 mm (Ver. 3.2 or later: 3 mm/7 mm selectable)
occurs by performing a back feed from the cutting position before feeding the next sheet or printing.
Note that back feeds will not occur even if they back feed is enabled, after executing a full cut after a
partial cut.
Also, settings according to MSW1-9 are disabled because in Raster mode, a raster command sets whether
to disable or enable back feeds. MSW1-A settings are enabled only for Ver. 3.2 or later.)
Back Feed Operations and Top Margin in Star Mode
MSW1-9 MSW1-A Previous Execution Command
<ESC> "d2"
Feed + Full Cut
Cut Commands Other
Than at Left
0 0
Back Feed: No
Top Margin
Approx.13mm
Back Feed: No
Top Margin
Approx.13mm
0 1
Back Feed: No
Top Margin
Approx.13mm
Back Feed: No
Top Margin
Approx.13mm
1 0
Back Feed: Yes
Top Margin: Approx.
3mm
Back Feed: No
Top Margin
Approx.13mm
1 1
Back Feed: Yes
Top Margin: Approx.
7mm
Back Feed: No
Top Margin
Approx.13mm
15-3
To Next Page
Loading...
