Do I need to Re-sync?
NOTE: Syncing will not improve heart rate and is not a calibration; it should only be used to Sync (Pair up) the
cadence sensor and the computer so that RPM can be transmitted.
Perform the Syncing process after checking all of the following:
• Is the battery secure in the cadence sensor and the cover tight?
o A loose battery will prevent the cadence sensor from transmitting
the RPM signal to the computer.
• Is the magnet aligned with the cadence sensor?
o A missing magnet or one that is not lined up properly will prevent the
cadence sensor from transmiting the RPM signal to the computer.
o The cadense sensor LED will blink for the first few revolutions at start up. If
the LED does not blink, check the magnet alignment before changing the batteries.
• Does the computer turn on when you press a button?
o If the computer does not turn on, replace the batteries in the computer.
• The computer turns on but as you pedal it does not show the RPM.
o If you have performed all of the above steps, you may now sync the computer and cadence sensor.
This will make them a paired set and will be able to transmit and receive the RPM signal.
10
To Next Page
Loading...