Star Trac Spinning Computer - Mounting Computer on Handlebars - Pro;Elite;NXT; Pro;Elite;NXT Handlebar Mounting Procedure

Time required:
• 15 Minutes
Parts required:
• 727-0100 Spinning
®
Computer Kit
Tools required:
• 5 mm Allen Wrench
• 2 mm Allen Wrench
1. Install the mounting bracket to the center flat section of the handlebar
by slightly prying the computer bracket clamp open.
2. Secure clamp down by tightening the M6x20 screw and M6 nut.
Mounting Computer On Handlebars - Pro 7070 / Elite 7080 / NXT 7090 Maintenance Checklist
21