If the tag is lost from view while the doors, hood, or trunk are open, the system will notify about
this event in one or more of the following ways:
Siren notification about cancellation of transition to the "Armed" mode;
Cancellation of transition to the "Armed" mode.
If the connection is lost or the tag's power element is depleted during the trip, but an event is
recorded inside the cabin, the system will ignore the tag signal loss. Ten seconds after the door is
opened, the system will automatically switch to the "Alarm" mode.
Disabling "Hands-Free" Mode for 1 Security Cycle
If the tag remains within range during parking (for example, you're in a cafe while your car is
parked nearby), it is recommended to disable the security deactivation in "Hands-Free" mode for 1
security cycle. After completing the security cycle, the system will automatically return to its
previous operating mode after opening one of the doors, the trunk, or the hood.
You can disable the security deactivation in "Hands-Free" mode for 1 security cycle using one of
the following methods:
Arming the security system by pressing a button on the tag;
Arming the security system using the standard key fob;
Arming the security system with two commands using the standard key fob within 10
seconds.
Successful disabling of the "Hands-Free" mode for 1 security cycle will be confirmed by 1 audible
signal.
If the system is in the "Disarmed" mode while the vehicle owner is nearby (for example, unloading
the trunk at the cottage), it is recommended to disable the security activation in "Hands-Free"
mode for 1 security cycle. After turning on the ignition or sending the "Arm" command, the system
will automatically return to its previous "Hands-Free" mode.
You can disable the security activation in "Hands-Free" mode for 1 security cycle using one of the
following methods:
Disarming the security system by pressing a button on the tag;
Disarming the security system using the standard key fob;
Disarming the security system with two commands using the standard key fob within 10
seconds.
By default, the tag's operating range is set to the maximum value. To change it, please
contact an installation specialist.
In the "Hands-Free" mode, automatic arming will not be executed if the tag is within sight.
To Next Page
Loading...