Alarm Mode
The "Alarm" mode is activated when any of the zones in the "Armed" mode is breached. The
system will trigger the siren and the hazard lights for 30 seconds and notify the owner via the
remote key. If the zone is not restored, the system will repeat the alarm cycle one more time.
When one of the warning zones is breached, 3 sound signals and 3 light signals will follow.
Resetting the "Alarm" mode without disarming the system is done by a short press on buttons
icon-short-1.png
Image not found or type unknown
or
icon-short-2.png
Image not found or type unknown
on the remote key.
Notification options is configured by an installation specialist:
Sound notification with siren and hazard lights
Notification with hazard lights only
No light or sound indication
Panic Mode
The "Panic" mode is designed to ensure the safety of the owner and the vehicle.
This mode is activated by the owner’s command via a double press on button 1 of the remote key(
icon-short-1.png
Image not found or type unknown
icon-short-1.png
Image not found or type unknown
). Upon receiving the command, the system activates
the siren and hazard lights for 10 seconds to attract attention.
Anti-Hijack Mode
The "Anti-Hijack" mode is designed to protect the driver from robbery during driving. The system
switches to this mode either by the owner’s command or when the tag/remote key is not detected.
By default, the "Keyless Entry System Lock" function is disabled. Contact an installation
specialist to activate it.
By default, sound notification with siren and hazard lights is enabled.
The maximum number of zone activations is limited to 8 cycles per arming period.
This mode can also be used to locate the vehicle in a parking lot.
To Next Page
Loading...