If authorization fails, the security system will switch to the "Alarm" mode.
Immobilizer mode
The Immobilizer Mode prevents movement without additional owner authorization.
Upon disarming or turning off the ignition, the system will wait for authorization confirmation either
by the presence of the key fob in the vicinity or by entering the owner's authorization code using
the vehicle's standard buttons (e.g., multimedia or window control buttons) while the ignition is on.
If owner authorization is not confirmed within 1 minute, attempting to start the engine will result in
it being locked for 1 minute or until the owner's authorization is successfully completed.
Vehicle Status Control
With this function, users can request information such as engine and cabin temperature, battery
voltage, and fuel level.
Requests can be made by the owner with a short press of the remote key button
icon-short-3.png
Image not found or type unknown
.
The information will be displayed on the remote key's screen.
Engine Start Function
The engine start function allows remote and automatic engine starting/stopping.
Preparing a Manual Transmission (MT) Vehicle for Remote and Automatic Engine Start
Before starting the engine, you need to perform the "Program Neutral" procedure:
When the Immobilizer Mode is enabled alongside the "Slave" mode, both authorization
conditions must be met to disarm the system.
The engine temperature readings displayed by the system depend on the location of the
engine temperature sensor and may differ from those shown on the vehicle's dashboard.
If the request is made during automatic engine start, the remaining engine runtime will also
be displayed in addition to the aforementioned values.
To Next Page
Loading...