Function «Engine starting preheater»
The function allows for engine preheating before starting. The starting preheater can be controlled
both in the manual and automatic mode.
Manual mode
In the manual mode the starting preheater is switched on/off by a command.
The starting preheater can be switched on by sequentially pressing buttons 2 and 1 on the remote
key:
icon-long-2.png
Image not found or type unknown
icon-note-1.png
Image not found or type unknown
icon-short-1.png
Image not found or type unknown
.
Operation can be prolonged by sending a repeated command for starting preheater switch-on.
The starting preheater can be switched off by sequentially pressing button 2 on the remote key:
icon-long-2.png
Image not found or type unknown
icon-note-1.png
Image not found or type unknown
icon-short-2.png
Image not found or type unknown
.
Automatic mode
In automatic mode, the preheater is activated before remote and/or automatic engine start.
Automatic engine start can occur under the following conditions:
Based on temperature value — preheater starts when the engine temperature drops
below a set value.
Based on the alarm clock — preheater starts at a specified time.
The temperature value and schedule are set in the remote key cursor menu.
The preheater operates for 20 minutes in this mode. To change its duration, consult your
installation specialist.
If the preheater has factory settings different from those set by the installation specialist,
the operating time may differ from the specified time.
To protect the engine from overheating, the preheater will stop when the maximum
temperature threshold specified during the security system setup is reached. This helps
protect the engine from overheating.
The automatic mode is activated by the installation specialist during complex setting after
mounting.
To Next Page
Loading...