Starline A90 - Hands-Free Mode

The algorithm works as follows:
One of the security zones is breached (doors, hood, or trunk);
The motion sensor is triggered;
After 30 seconds, the system starts searching for the tag/remote control;
If the tag/remote control is not detected within 30 seconds, the system will activate
warning signals about the upcoming engine blocking with the siren and hazard lights for
10 seconds;
The engine will be blocked either after 3 minutes or upon pressing the brake pedal.
The exit from the "Antihijack" mode due to the disappearance of the tag or remote control can be
done in one of the following ways:
When the tag/remote control reappears within range;
By entering the emergency disarm code, specified on the owner's PIN envelope, using the
service button.
Hands-Free mode
The "Hands-Free" mode is designed for automatic enabling/disabling of the security mode.
You can enable or disable the "Hands-Free" mode in the cursor menu of the remote key by
selecting the corresponding item;
There are several options for enabling and disabling the alarm in the "Hands-Free" mode:
Enabling the alarm when the tag is lost from sight
Enabling the alarm by holding the door handle sensor (purchased separately) with the tag
in sight
Disabling the alarm when the tag appears in sight
Disabling the alarm by touching the door handle sensor (purchased separately) with the
tag in sight
If the emergency disarm code is entered incorrectly 3 times, the ability to enter the code will
be blocked for 15 minutes, and the owner will receive an SMS notification.
By default, the "Anti-Hijack" by tag or remote key loss option is disabled. To enable it, hold
the tag button until a long red flash appears, then release the button.
By default, the "Hands-Free" mode is disabled. All mode operation parameters are
configured by the installation specialist during installation.