Successful disabling of the "Hands-Free" mode for 1 security cycle will be confirmed by 1 audible
signal.
Service mode
Service Mode is intended for temporarily disabling security functions and restricting access to
system settings. It is recommended during service maintenance.
The following functions and modes are unavailable in Service Mode:
Arming and disarming the security system;
"Hands-Free" mode;
Unlocking and locking the central lock during a trip;
Remote and automatic engine start;
"Turbo Timer" function;
Pre-heater control;
Trunk release;
Transition to the "Panic" mode;
Activation of the "Anti-Hijacking" mode by tag or key fob loss;
Main unit calibration procedure;
You can enable and disable the Service Mode using one of the following methods:
Selecting the corresponding item in the tag cursor menu;
Short press of the buttons
icon-service-mode.png
Image not found or type unknown
of the remote key;
Holding down the tag button for 5 seconds;
Entering Service Mode will be confirmed by a yellow LED indication on the tag.
Automatic Exit from Service Mode
The system will automatically exit Service Mode and wait for owner authorization when leaving the
service station based on the established event with the ignition on. After successful authorization,
the system will switch to the "Disarmed" mode.
Enabling Service Mode is only possible from the "Disarmed" mode near the vehicle.
In Service Mode, transition to other additional modes is prohibited!
For this function to work, owner authorization must be enabled, sensors must be activated,
and vehicle speed information must be available.
To Next Page
Loading...