35
Change of owner authorization code
The owner code is used for user authorization by means of the
standard car buttons.
Do as follows to change the owner authorization code:
1) Deactivate system security.
2) Switch o ignition (if it is on).
3) Press the service button 7 times.
4) Switch ignition On. 7 service button LED
ashes and 7 siren sounds will follow. Entry in
registration mode will be conrmed by 2 short
LED ashes and 2 siren sounds.
5) Enter a new owner authorization code using
the standard car buttons with pressing interval
not more than 3 seconds. Each pressing of the
standard button will be accompanied with a
single ash on service button LED.
To Next Page
Loading...
