by reached a speed below 30 km/h engine will be safely stopped.
2. The mode operation sequence when speed from CAN bus is not supported:
any of secured zones has been breached (doors, hood or trunk)
motions sensor has triggered
in 30 sec system begins seeking for a tag or remote key
in another 30 sec, if a tag or remote key has not been detected, system enables
warning sound and lights for 10 sec
engine will be stopped in 3 min or at brake pedal pressing.
Exit from Anti-hijack mode by a tag or remote key loss is made by one of following ways:
when tag or remote key is detected in range
SMS text command 30 XXXX, where XXXX - emergency disarm code from ID card
entering emergency disarm code with service button or external transceiver button
at starline.online personal account with entering emergency disarm code
In case of invalid emergency disarm code is entered 3 times, then a code entry will be
blocked for 15 min and owner will be informed with text message.
Slave mode
Slave mode allows to control security system by means of a factory remote control or
Keyless-Go system.
System detects unlocking doors and disarming factory security and waits for owner
authorization with any of below methods before disarming itself:
! Waiting for authorization starts at any of door, hood and trunk open.
tag or remote key detection in range at disarming during adjusted interval from 15 to
60 sec
entering personal PIN code with factory buttons at ignition On during adjusted
interval from 15 to 60 sec
If authorization failed with any of methods then system shall activate warning siren sounds
and then turn to alarm mode.
It is highly recommended to enable above mentioned secondary owner authorization
methods in Slave mode in system configuration settings.
Hands free mode
Hands free mode allows automatic system arming and disarming by a tag loss and
detection in range.
The mode is enabled and disabled by one of following ways:
SMS text commands 71 or 70 accordingly
29
To Next Page
Loading...
