Starline S9 - Wireless Tag Control

Embedded buzzer sound indication
Events Sounds
Waiting for authorization 10 sec
Tag battery discharged (at ignition On)
Valid authorization PIN code entered
Invalid authorization PIN code entered
Control with wireless tag (transponder) (optional accessory)
! Wireless tags availability depends on delivery set.
! The included and optional tags are supplied from factory in transport (power saving)
mode, i.e. inactive! Pushing a tag button in this mode is indicated by green and red
alternating flashes of the built-in LED. To switch it to normal mode push a tag button
several times until flashing color turns to green.
Connection check
Push button once to check tag connection status. 2 LED flashes means connection with
security main unit established, 1 flash means disconnected. A flash color corresponds to
the current active mode:
 green – Regular mode, Anti-hijack is disabled
 red – Anti-hijack mode is enabled
 yellow – Service mode is enabled
Control over security system
Duration of a tag button pushing:
• short – push and release button, followed with a flash of corresponding current
operation mode;
• long – push and hold button until LED begins flashing.
Duration of long push are of 2 levels:
• 1 level – push and hold button followed with double short flashes of a current
10