STC-AD3
www.stealthcam.net Toll Free 877-269-8490
30
Using the camera in PIR detection mode
• Mount the camera to tree or other sturdy object using either
two supplied tree screw or mounting strap (Please refer to the
mounting suggestions section in this manual)
• Open the front housing and move the switch to the ON position.
• The camera’s green test light will begin blinking and enter
count down mode. This is your indication to leave the coverage
area within one minute.
• After one minute the camera will take between 1~3 pictures or
a 10 seconds AVI video based on your program setting. The
camera will then time out between 1 ~ 60 minutes also based
on your setting.
The time between motion detection and the camera taking
the pictures may vary due to lighting conditions, charging
of the flash, program setting and battery power level.
The flash light will only activate in low light conditions
when set in Auto Flash.
When the camera is set to AVI capturing, the 10 seconds
To Next Page
Loading...
Need help?
General
