Stedi ModelSmart Pro 280 - Page 20

20
VIEW MODEL SAMPLES
Clicking the buon will give you access to the available models, as you saw on the home screen.
ADD MODELS FROM COMPUTER
Clicking the buon will allow you to search for your own models on your computer.
DUAL PRINTING MODE
If you have the ST3Di ModelSmart Pro 280 you will see this buon .If you click this
buon before loading models it will merge two les that form part of the same model. For example if you are
prinng a two colour print via the dual extruders, each colour will be loaded as an individual model; clicking this
buon will merge the two together so that they print as one object.
SELECTING THE EXTRUDER
COPY MODELS
The buon allows you to replicate a selected model in its current state, mulple mes within
the same Scene.
PLACE MODEL ON THE BED
The buon resets a selected model to the bed of the Scene if it has been moved either above
or below the bed during eding.
RESET CHANGES
The buon will return the model to the exact state it was when rst loaded, undoing any eding
changes you have applied.
REMOVE SCENE
The buon will remove a selected object from the Scene.
The panel on the right hand side of the screen gives you the ability
to move, scale and rotate your object. Ticking the scale buon will
enable you to scale your model uniformly.
The dual prinng funcon on the ModelSmart Pro 280 allows you to select
which extruder you use to print each object within a Scene. If you select
dierent extruders for dierent models they will be shown on screen in
dierent colours to conrm your selecon. Please note however that the
on-screen colours are not representave of the lament colours you have
installed in the printer, and subsequently therefore are also not representave
of the colour of the nal print.
LOCATION
Name Sheri Badge
X Y Z
Position 0.00 0.00 0.00
Rotation 0 0 0
Scale 1.00 1.00 1.00
Samples
Enable dual-print mode
Select extruder to use for print
Left Right
Copy
Reset changes
DELETE