Steinbach Poolrunner Battery Basic - Inserting the Filter Unit; Placing the Device in the Pool and Starting Cleaning

Inserting the filter unit
1. Make sure that the dirt slots
11
are
closed before inserng the lter unit.
2. Insert the lter unit
2
into the boom
part
3
in the correct posion with the
guide lugs poinng upwards.
3. Place the top part
1
in the correct
posion on the boom part
3
. In doing
so, pay aenon to the guide lugs on
the marked locking points.
4. Close all clips
12
.
The lter unit is inserted.
Placing the device in the pool and starting cleaning
CAUTION!
Risk of injury!
The device can hurt persons in the pool.
-
Make sure no one is in the pool while the device is in the water.
NOTICE!
The pump of the device can be damaged if it is switched on or o
outside of the water.
- Only switch the device on or o when it is located below the
water surface.
9
2
11
3
10
1
3
12
38