Steinbach Poolrunner Battery Basic - Lifting the Device Out of the Pool; Cleaning

Lifting the device out of the pool
NOTICE!
The pump of the device can be damaged if it is switched on or o
outside of the water.
- Only switch the device on or o when it is located below the
water surface.
1. Slowly pull the device to the surface by the oang handle
5
and the nylon cord
unl you can reach the handle
8
and press the ON/OFF
13
switch on the boom
unl it snaps into place.
If the oang handle is out of reach, use the supplied hook
6
together with an
extensible rod (not part of the package contents).
The device is switched o.
2. Slowly li the device out of the water by the handle and hold it above the water
surface for 10 to 15 seconds so that most of the water can ow back into the pool.
3. Set down the device next to the pool.
The device is lied out of the pool.
Clean the device aer each use to ensure connued fault-free operaon.
Cleaning
NOTICE!
Improper cleaning might damage the device.
- Clean the surface of the device with plain tap water aer each
use.
- Do not use any aggressive cleaning agents.
-
Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
-
Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
40