Steinbach Poolrunner Battery Basic - Troubleshooting

Troubleshooting
Fault descripon Cause Remedy
The device cannot be switched
on.
The rechargeable baery is
drained.
Charge the rechargeable
baery.
The rechargeable baery is
defecve.
Contact customer service.
It takes about 15 seconds aer
the ON/OFF switch is pressed
before the device starts.
Wait approximately 15 seconds
unl the device starts.
The charge control indicator is
not lit.
The charger is defecve. Contact customer service.
The device beeps. The device is out of the water. Place the device in the water.
The device connues beeping
aer it has been placed in the
water.
The device is defecve. Contact customer service.
The device cannot reach all
spots.
The wheel seng does not t
the pool size.
Adjust the wheels to t the
pool size.
The pool has a special shape. Adjust the wheels. Select the
seng for small pools.
The water circulaon of the
pool is switched on.
Switch o the lter system of
the pool.
The device does not turn
around at the pool wall.
The sail, the water discharge
nozzle or the cleaning strip is
stuck.
Remove the obstrucon,
remove the cleaning strips or
contact customer service.
The device oats up or turns in
a circle on the pool oor.
Too much air in the housing. Let all air escape.
The pH value and the chlorine
quanty are not properly set.
Adjust the pH value to the
correct value. See secon
"Technical data".
The salt content is too high
and the device has more
buoyancy.
Set the correct salt content.
See secon "Technical data".
42