EasyManua.ls Logo

Steinbach Poolrunner Battery Basic - Switching Off the Device

Steinbach Poolrunner Battery Basic
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Hold the device by the handle and
lower it slowly into the water unl all
the air has escaped. The device should
run at a right angle to the pool wall.
2. Press the ON/OFF switch
13
on the
boom unl it snaps into place.
The device beeps if it is switched on outside of the water.
The device starts approximately 15 seconds aer the switch has been
pressed.
3. Aerwards, carefully lower the device on the nylon cord of the oang handle
5
to
the boom.
The device is in the pool and starts cleaning with a me delay.
Cleaning stops automacally when the rechargeable baery is drained.
Press the ON/OFF switch
13
to stop cleaning and switch the device o before
the cleaning me is up.
Switching off the device
Proceed as follows to switch o the device:
1. Li the device out of the pool and switch it o.
2. Clean the lter unit and the device.
11
12
13
39

Table of Contents

Other manuals for Steinbach Poolrunner Battery Basic

Related product manuals