INSSTCNP15MA0914
11
is effective. The gures that replace the ambient temperature
indicate the current timer adjustment. If needed, adjust the
timer by pressing down the + button to increase the value, or
the - button to decrease it. The Night mode timer adjustment
range is from 1 hour to 23 hours in the Single programming
mode. To quickly scroll through the timer values, press and
hold down the button.
N.B. If you set the timer to any value exceeding 23 hours, it will
be impossible to activate the Single programming mode
and if it was activated, the Single programming mode will
be deactivated.
3. Activate the Single programming mode by simultaneously
pressing down the + and - buttons for at least 3 seconds.
The
icon will appear. If the Single programming mode
was already activated, the same procedure should be used
to deactivate it.
4. When the adjustment is completed, release the buttons and
wait for 5 seconds to exit the adjustment function.
N.B. It is always possible to manually change the Day/Night
mode during a 24-hour cycle. In all cases, at the end of the
24-hour cycle, the thermostat will return to the Night mode
and start a new cycle. It is thus not necessary to readjust
the Single programming mode when a manual change is
made to the Day/Night mode. If the thermostat is set off
(--), the Single programming mode will be deactivated.
When the power is restored after a power failure for
example, the Single programming mode is deactivated
and its corresponding icon is blinking. The icon will stop to
blink as soon as you will press down a button.
Display in Degrees Celsius/Fahrenheit
The thermostat can display the ambient temperature and
the set point in degrees Celsius (standard factory setting) or
Fahrenheit.
To Next Page
Loading...
