INSSTCNP15MA0914
12
Adjustment procedure for degrees Celsius/Fahrenheit display.
1. To switch from the degrees Celsius to the degrees
Fahrenheit, and conversely, the thermostat must be from
the Day mode. If so, simultaneously press down the + and -
buttons for more than 3 seconds until the
icon blinks.
2. Press down the + button to switch from the degrees Celsius
to the degrees Fahrenheit, and conversely. The degree
Celsius or Fahrenheit symbol is displayed.
3. When the adjustment is completed, do not press down any
button during 5 seconds to exit the adjustment function.
/ Mode
To switch from the mode to the mode, or conversely,
press down the A/F button (when you are not in any adjustment
mode). The previous temperature set point of this mode will be
restored.
Safe mode
If the thermostat fails to detect the presence of a oor sensor, it
will automatically revert to mode at a setpoint of 21°C. (with
a maximum set point temperature of 24°C)
Sensor Selection
If you want to use the STCNP thermostat of Stelpro with a
temperature sensor already installed in the oor (other than
the sensor supplied with this thermostat), you must contact the
Stelpro customer service to validate the compatibility between
the sensor and the thermostat. You must know the serial
number and name of the installed sensor.
Temperature Control
The thermostat controls the / temperature (according
to the / mode) with a high degree of accuracy. When
the heating starts or stops, it is normal to hear a “clic” sound. It
is the noise of the relay which opens or closes, as applicable.
To Next Page
Loading...
