Stelpro STCNP - Ambient Mode

INSSTCNP15MA0914
3
The STCNP single programming electronic thermostat can be
used to control heating oors with electrical current − with a
resistive load − ranging from 0 A to 16 A at 120/208/240 VAC. It
has an easy user interface. It keeps the temperature of a room
( mode) and a oor ( mode) at a requested set point with
a high degree of accuracy.
Floor Mode (factory setting)
This control method is ideal in areas where you want a hot oor
at any time and when the temperature of the ambient air can be
high without causing discomfort.
Ambient Mode / (you only have to press down the A/F
button to switch from one mode to the other)
This control method is ideal when you want a stable ambient air
temperature (without uctuation). Usually, this mode is used in
large and often occupied rooms where temperature variations
can be uncomfortable. For example, in a kitchen, a living room
or a bedroom.
Some factors cause variations in ambient air temperature. They
include large windows (heat losses or gains due to outside
temperature) and other heat sources such as a central heating
system, a replace, etc. In all these cases, the
mode will
ensure a uniform temperature.
This thermostat is not compatible with the following
installations:
• electrical current higher than 16 A with a resistive
load (3840 W @ 240 VAC, 3330 W @ 208 VAC and
1920 W @ 120 VAC);
• inductive load (presence of a contactor or relay); and
• central heating system.
DESCRIPTION