CHANGING THE OIL IN GEAR BOXES
650/800/850 GUEPARD
81
5.
Remove the oil filter cover.
6. Replace the oil filter filtering element.
7. Install the oil filter cover.
8. Fill the required amount of the recommended engine
oil in the filler cap.
9. Insert the oil feeler gage to a stop and screw it.
Recommended engine oil:
10W-40 SF
Volume (primary fill):
without filter replacement 2.750л
with filter replacement 3.150л
10. Start the engine and let it operate at idle speed
for several minutes, then check it for leaks. In
case of oil leaks signs, stop the engine
immediately and correct the cause of the leaks.
11. Stop the engine and wait for 10 min. Then check
the oil level with a feeler gage, and correct it,
if necessary.
12. Install the side panel.
Front axle housing oil replacement
Prior to every trip, check the front and rear axles for
oil leaks. In case of leakage detection, contact the
repair workshop to correct the fault.
To replace the oil carry out the following operations:
1. Park the vehicle on a flat surface.
2. Place the reservoir under the front axle to drain
the used oil into it.
3. Unscrew the oil filler cap bolt and the drain
opening bolt-plug to drain the oil.
1. Oil filler cap bolt. 2. Bolt-plug for oil draining.
manufacture website : stelsoffroad.com
To Next Page
Loading...
