82
650/800/850 GUEPARD
CHANGING THE OIL IN GEAR BOXES
4. Drain the oil.
5. Screw the bolt-plug for oil draining into the opening.
The bolt-plug tightening torque: 10 Nm
6. Add the recommended oil into the front axle
housing - 250 g (up to the lower control opening
brim).
Recommended oil in the front/rear gear boxes:
transmission gear oil
SAE75W90 API GL-5
7. Screw in the oil filler cap bolt and tighten it with a
torque wrench.
8. Assure the absence of oil leaks.
Rear axle housing oil replacement
To replace the oil carry out the following operations:
1. Park the vehicle on a flat surface.
2. Place the reservoir under the rear axle to drain
the used oil into it.
3. Unscrew the oil filler cap bolt and the bolt-plug to
drain the oil.
1. Oil filler cap bolt.
2. Bolt-plug for oil draining.
4. Drain the oil.
5. Screw the bolt-plug for oil draining into the opening.
The bolt-plug tightening torque: 10 Nm
6. Add the recommended oil into the rear axle - 250 g.
7. Assure the absence of oil leaks.
manufacture website : stelsoffroad.com
To Next Page
Loading...
