13
USA and Canada 800.683.2378, International 904.641.1666 Econ T
PROGRAMMING continued
3. SET ADDITIONAL TIMERS: TIMER 02 THROUGH 24, AS NEEDED
Press the
TIMER button and repeat the above steps for each timer.
When finished setting the desired timers, press the CLOCK button to return to the
operating display.
NOTE: DO NOT overlap timer programs. If timers are overlapped, the first timer to
activate will run until the first OFF time of any overlapped timers is reached.
4. REVIEW PROGRAMS
Press the TIMER button repeatedly to view the settings for all 24 ON and OFF events.
Press the CLOCK button at any time to return to the operating display. The display will
show the current day, time, and the pump mode of operation; either AUTO, ON or OFF.
5. OPERATING MODE
Auto
Press the MANUAL button to set pump to AUTO. The AUTO mode enables the timers to
run at the programmed times and the display will show the last timer to run.
NOTE: When in AUTO mode, the display will show the last timer to run. If you enter into
the timer programming menu and then come back out, it will clear the indicator of the
last timer that ran and the timer indicator will be blank until a timer starts to run.
Manual
Manual mode is for priming only. If left in the manual mode, the pump will stop at
midnight (00:00) and the operating mode will have to be manually set again.
To prime the pump, press the MANUAL button to set the pump to ON. When pump is
set to ON, it will run continuously and bypass any programmed timers. To stop the
pump from running in MANUAL or from running the programmed timers, press the
MANUAL button to set the pump to OFF. The pump will remain off until the operating
mode is changed to ON or AUTO.
To Next Page
Loading...
