12
www.stenner.comEcon T
PROGRAMMING
FIRST TIME USE
NOTICE: Indicates special instructions or general mandatory action.
Before programming for the first time, the control panel must be reset to the
default settings. Press and hold the CLOCK and TIMER buttons simultaneously
for 5 seconds. The clock will display 00:00 and the timers will be disabled.
1. SET THE CLOCK
Press and hold down the CLOCK button, then press the DAY, HOUR, and MINUTE buttons
to adjust to the current day and time.
When the current day and time is set, release the CLOCK button. The clock is now set.
2. PROGRAM THE FIRST TIMER: TIMER 01
a. Set the Time and the Day for the Pump to Start
Press the TIMER button once. The display will show TIMER 01 ON.
Press the DAY button to select the day or days that the timer will run. Press the
DAY button repeatedly and the following choices will be displayed:
SUN = Sunday only
MON = Monday only
TUE = Tuesday only
WED = Wednesday only
THU = Thursday only
FRI = Friday only
SAT = Saturday only
SUN MON TUE WED THU FRI SAT = All days
MON TUE WED THU FRI = Monday through Friday
SUN SAT = Sunday and Saturday
MON WED FRI = Monday, Wednesday and Friday
TUE THU = Tuesday and Thursday
Press the
HOUR and MINUTE buttons to set the ON time for the timer.
NOTE: Individual timers can be disabled by setting the on time hour and minutes
to “- - : - -”.
b. Set the Time for the Pump to Stop
Press the TIMER button. The display will now show TIMER 01 OFF.
NOTE: The days selected for the ON time will be shown and cannot be changed.
Press the
HOUR and MINUTE buttons to set the OFF time for the timer.
To Next Page
Loading...
