74
4.4 Mini wireless remote control
Using the mini wireless remote control you can adjust the temper-
ature setting wirelessly. Encoding prevents other wireless remote
controls from changing the settings.
Obstacles can affect the transmission path between the appliance
and the mini wireless remote control.
You can use the mini wireless remote control while having a show-
er or bath.
The mini wireless remote control is delivered paired to the instan-
taneous water heater.
OFF 3s
38 60
+
_
D0000033105
3
1
2
1 "+" and "-" temperature setting
2 Temperature adjustment 38 and 60°C direct selection
buttons
3 LED
Press a button on the mini wireless remote control. This
transmits data to the appliance. The red LED confirms
that the button information has been transmitted to the
appliance.
You can switch the appliance heating system to "OFF" using
the mini wireless remote control. Press and hold "-" for
≥3seconds. Press any button to switch it back on.
If the battery is empty, see chapter "Troubleshooting/ Mini wire-
less remote control battery replacement".
4.5 Pairing new/additional programming units
The DHEprogramming unit allows you to operate the appliance
remotely (for wireless remote controls, see chapter "Installation/
Accessories"). Encoding prevents the transmitters of third party
appliances changing the settings.
Obstacles can affect the transmission path between the appliance
and the programming unit.
You can pair the programming unit as follows:
Using the programming unit built into the instantaneous
water heater, open the "Service/ Wireless/ Connect other
wireless subscribers" menu item.
Open the "Service/ Wireless/ Pair programming unit" menu
item on the programming unit to be paired.
Press "OK" on the programming unit to be paired.
To Next Page
Loading...
Need help?
General
