ENGLISH
91
D0000053276
1 2
1 Connected load button
2 Display
Press the connected load button briefly to wake up the dis-
play. The set connected load flashes.
Then press the button repeatedly until the required connect-
ed load appears on the display. The connected load selected
is adopted immediately.
12.1.2 Mini wireless remote control
The mini wireless remote control is factory registered to the ap-
pliance. If no data transmission takes place during commission-
ing, repeat the pairing process (see chapter "Installation options/
Pairing the mini wireless remote control".
12.1.3 Appliance handover
Explain the appliance function to users and familiarise them
with how it works.
Make the user aware of potential dangers, especially the risk
of scalding.
Hand over the instructions.
12.2 Recommissioning
!
Material losses
To ensure that the bare wire heating system is not dam-
aged following an interruption to the water supply, the
appliance must be restarted by taking the following steps.
Isolate the appliance from the power supply; do this
by removing the fuses or switching the appliance to
"OFF".
Open the tap for one minute until the appliance and
its upstream cold water inlet line are free of air.
Switch the power supply back on, or set a tempera-
ture on the appliance or wireless remote control.
13. Appliance shutdown
Isolate all poles of the appliance from the power supply.
Drain the appliance (see chapter "Installation/ Maintenance/
Draining the appliance").
To Next Page
Loading...
Need help?
General
