STIEBEL ELTRON SNE 5 t ECO - Time Programs

OPERATION
Settings
20 | SNE 5 t ECO www.stiebel-eltron.com
4.4.2 Time programs
There are three time programs available when using the appliance
in timer mode. Time programs Pro1 and Pro2 are pre-configured
at the factory. The Pro3 time program can be set in accordance
with your individual preferences.
Display Description
Pro1 Repeated: Daily
Suitable for private households, for example
Pro2 Repeated: Weekdays
Suitable for workplaces, for example
Pro3 user defined
Note
Ensure the day of the week and the time are set correctly
when setting the time programs.
Note
Timer mode is suspended when ECO mode ("ECO" button)
is activated.
Deactivate ECO mode using the "ECO" button.
Pro1 | Pro2
You can specify the comfort mode start and end times with time
programsPro1 and Pro2. Outside this specified time period, the
appliance operates in setback mode. This results in a comfort
phase and a setback phase, which are repeated daily(Pro1) or on
every working day (Pro2).
Theses phases are factory-set as follows:
- 08:00h - 22:00h: Comfort mode
- 22:00h - 08:00h: Setback mode
Note
When time programPro2 is enabled, the appliance oper-
ates at weekends exclusively in setback mode.
To set time programsPro1 and Pro2 according to your preferences,
proceed as follows:
 In the configuration menu, use "+" and "–" to call up the re-
quired time program.
 Press "OK".
The start time for comfort mode is displayed.
 Use "+" and "–" to set the required start time.
 Press "OK".
The end time for comfort mode is displayed.
 Use "+" and "–" to set the required end time.
 Press "OK".
The time program is configured.
Pro3
You can use time programPro3 to specify up to 14 separate com-
fort phases which are repeated weekly.
To configure a comfort phase in time programPro3, proceed as
follows:
 In the configuration menu, use "+" and "–" to call up time
programPro3.
 Press "OK".
The display shows "3---".
 Press "OK".
The day of the week or a group of days is displayed.
 Use "+" and "–" to select the required day or group of days.
 Press "OK".
The start time for comfort mode is displayed.
 Use "+" and "–" to set the required start time.
 Press "OK".
The end time for comfort mode is displayed.
 Use "+" and "–" to set the required end time.
 Press "OK".
Comfort phase "3-01" has been configured. The Pro3 time
program is displayed again.
 Press "OK" to configure a further comfort phase. Use "+"
and "–" to select the "3---" display. Proceed as described
previously.
Note
The following applies to all time programs (Pro1, Pro2,
Pro3):
- If the end time is before the start time, the end time
will automatically be moved to the next day of the
week. The comfort phase is maintained past mid-
night and will end on the next day at the set end
time.
Note
Activate the required time program in the standard menu
(see chapter "Operation/ Settings/ Standard menu").
Note
To reset the selected comfort phases, activate parame-
terP5.
 Please note that activating parameter P5 resets all
appliance settings to the factory setting.