STIEBEL ELTRON SNE 5 t ECO - Appliance Specifications

INSTALLATION
Specication
26 | SNE 5 t ECO www.stiebel-eltron.com
Replacing the power cable
The power cable must only be replaced by a qualified contractor
with an original spare part. Alternatively, the H05VV-F3x1.0 cable
may be used.
D0000071890
 Route the power cable along the cable guide.
14.6 Positioning the temperature sensor in its
protective pipe
 Insert the temperature sensor into the protective pipe.
 Secure the temperature sensor in place below the earthed
plug.
15. Specification
15.1 Dimensions and connections
c06
c01
100
421
70
230
140
263
i13
14
328
D0000071747
SNE 5 t ECO
c01 Cold water inlet Male thread G 3/8 A
c06 DHW outlet Male thread G 3/8 A
i13 Wall mounting bracket
15.2 Wiring diagram
1/N/PE ~ 220 - 240V
X2X1
L
N
L
Out
L
N
Z1
Z3
X4
X3
ϑ
L N PE
D0000071846