Room temperature HC 1
With the menu item ROOM TEMP 1 you can
select the set room temperature for day and
setback mode for heating circuit 1. Changing
these parameters results in a parallel offset of
the heating curve.
The actual room temperature can also be
scanned, as soon as the FE 7 remote control
has been connected and allocated to heating
circuit 1.
DHW temperature
You can allocate a set day or night tempera-
ture to the DHW cylinder temperature using
the DHW TEMP menu item.
Open the control ap!
Open the control ap!
Room temperature HC 2
With the menu item ROOM TEMP 2 you
can select the set room temperature for day
and setback mode for heating circuit 2. You
can change the room temperature, if you feel
rooms are either too hot or too cold. ROOM
TEMP 2 will only be displayed, if the mixer
flow sensor is connected.
The actual room temperature can also be
scanned, as soon as the FE 7 remote control
has been connected and allocated to heating
circuit 2.
Open the control ap!
Adjustments at control level 2 for users and contractors
Roomtemp HC1
SET Roomt 1
SET Roomt DAY
SET Roomt NIGHT
SET Roomt NIGHT
Roomtemp 1
Back
Roomtemp HC1
Roomtemp HC2
Set Roomt DAY
Set Roomt DAY
Set Roomt night
SET Roomt night
Actual Roomtmp
Back
roomtemp hc2
DHW TEMP
SET DHW DAY
SET DHW DAY
To Next Page
Loading...
