Stiga A1500 - Garage and Device Page

34 EN
4. INSTALLATION
If the docking station is installed separately from the satellite reference station, it can be congured at a
later date.
Once the pairing is complete, the product's main page is displayed, from which it is possible to access all
available menus.
NOTE: If the docking station has been successfully paired, the indicator light on the docking
station will lit up with a steady light whenever the robot lawn mower is outside the docking
station. If pairing has not been completed, the indicator light ashes.
NOTE: After all devices have been paired, it is necessary to perform the "calibration of the
docking station" before using the product (see par. 4.7.5).
NOTE: if the robot lawn mower is not detected by the mobile device, make sure it is not paired
with another device (See Par. 5.3.6).
4.7.4. GARAGE AND DEVICE PAGE
The "Garage" section displays all Stiga products associated with the user prole.
The paired items are displayed by scrolling left or right through the dierent screens.
For each of the items displayed, it is possible to access a range of options allowing the user to:
• rename or delete the device from the user account
• access product information and manuals
• check the mobile network connectivity status and GNSS signal status of the robot lawn mower
and reference station
• make rmware updates
From the "Garage" section, you can access the "Product Page" of each associated item.
The robot lawn mower product page is divided into three sections:
• Robot
• Settings
• My garden
It is possible to browse all sections by scrolling left or right through the dierent screens.
The "Robot" section allows users to:
• Check the robot lawn mower status (battery level, operating status, selected cutting mode)
• Starting and stopping the robot lawn mower
• Forcing the robot lawn mower to return to the docking station
• Starting the robot mower to work in an area that cannot be reached independently (if available on
the app)
• Check remaining connectivity hours and renew the data package
The “Settings" section allows users to:
• Select either “Spot Cut “ or “Scheduled" cutting mode
• Set-up or change the work programme
• Set-up or change the cutting height
• Calibrate the positioning of the robot lawn mower in the docking station
• Start the hibernation procedure for winter storage
• Activate and select the rain sensor sensitivity
The "My Garden" section allows users to:
• Record virtual boundaries, transfer routes and areas to be avoided using the app wizard.
• Display the garden map with recorded items and the robot lawn mower's real-time position.