Stihl FS 200 - Mounting the Loop Handle

FS 120, FS 120 R, FS 200, FS 250, FS 250 R
English
22
Swiveling the handlebar
Into the transport position
N Loosen the tommy screw (3) and
unscrew it until it is possible to
swivel the handlebar (7) clockwise
N Turn the handle bar 90° and then
swivel it downward
N Tighten tommy screw (3)
Into the working position
N Swivel and turn the handlebar
counterclockwise in the opposite of
the order described above
Mounting the Loop Handle with Barrier
Bar
N Fit the square nuts (1) in the barrier
bar (2); the holes must line up.
N Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N Place the clamp (6) against the
drive tube.
N Place the barrier bar (2) in position
as shown.
N Line up the holes.
N Insert the screws (7) and tighten
them down moderately against the
barrier bar.
N Go to "Securing the Loop Handle".
Mounting the Loop Handle
2
002BA098 KN
1
1
5
4
002BA099 KN
2
3
6
7