FS 120, FS 120 R, FS 200, FS 250, FS 250 R
English
38
N Check lubricant filling periodically
and after approx. every 25 hours of
operation
N Unscrew the locking screw (1) – if
no grease can be seen on the
inside, then screw in the tube (2) of
STIHL gear lubricant for
brushcutters (special accessory)
N Squeeze up to 1/5 oz (5 g) of
grease into the gear housing
Do not completely fill the gear housing
with grease.
N Unscrew lubricant tube (2)
N Refit locking screw and tighten
securely
Removing the Fan Housing
N Take out the screws (1).
N Remove the fan housing.
Replacing the Starter Rope
N Remove the spring clip (2).
N Carefully remove the rope rotor with
washer (3) and pawl (4).
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
N Pry the cap (5) out of the grip.
N Remove the remaining rope from
the rotor and starter grip.
N Tie a simple overhand knot in the
new rope and then thread it through
the top of the grip and the rope
bushing (6).
N Refit the cap in the grip.
Lubricating the Gearbox
Replacing the Starter Rope
and Rewind Spring
To Next Page
Loading...
