0458-507-0121-A
18
English
7 Adjusting Trimmer for User
► Rotate the metal cutting attachment (4) counterclockwise
until the stop pin (7) engages in position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it down firmly.
► Remove the stop pin (7).
6.6.2 Removing the Metal Cutting Attachment
► Shut off the engine.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the metal cutting attachment clockwise until the
stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal cutting
attachment and thrust plate.
► Remove stop pin.
7.1 Fitting and Adjusting the Carrying System
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand’s width below your right hip.
7.2 Balancing the Trimmer
The unit is balanced differently depending on the cutting
attachment used.
If a mowing head, grass cutting blade or brush knife is fitted:
The cutting attachment should rest lightly on the ground.
If a circular saw blade is fitted:
The saw blade must hover at a height of about 20 cm above
the ground.
► Shut off the engine.
7 Adjusting Trimmer for User
1 3
2
2
0000-GXX-4594-A0
0000-GXX-7836-A0
To Next Page
Loading...
