Page 10 Technical Information 40.2010
TI_40_2010_13_01_02.fm
3.7.2 Version with short drive tube, see b 4.4
1 Limit stop 200 mm for circular saw blades
2 Limit stop 225 mm for circular saw blades
The new limit stops are fastened with 3 screws
secured against loss.
For details about the approved deflectors and limit
stops, see b 5.2.
3.8 4-point anti-vibration system
Four anti-vibration elements for damping vibrations
are installed between the engine and the drive tube,
In addition to rubber buffers and annular buffers as
anti-vibration elements in the area of the engine,
steel springs are used as anti-vibration elements in
the area of the handlebars. The 4-point anti-
vibration system ensures a very low vibration level,
optimal control and reduced operating effort.
3.9 New full harnesses
3.9.1 Universal harness ADVANCE
– Functional, modern shape – outstanding
handling and ergonomics
– Very low weight: 0.74 kg
– Available in two sizes
The new universal harness ADVANCE includes an
exhaustive information sheet about putting on the
harness properly and the ways in which it can be
adjusted.
1
2
317TI015 KN
317TI017 KN
317TI018 KN
To Next Page
Loading...
